Document #: 00559

AutoLink fails with target directory error

Problem: Running AutoLink, the software tries to look for a FAT on the hardrive. If the hardrive is HPFS or NTFS, the following error message returns: "AutoLink fails with target directory error."

Solution:
1. Put a disk in drive B: and edit out the AUTOLINK.CFG file. Specify drive B:
2. Create a directory on the hard drive called NWCLIENT
3. Copy PACK.EXE from the @ directory on the EtherDisk to the NWCLIENT
4. Copy AUTOLINK.SAC from the QINSTALL directory on the EtherDisk to the NWCLIENT
5. Copy 3C5X9.COM and NET.CFG from the NETWARE\ODI directory on the EtherDisk to the NWCLIENT
6. From the NWCLIENT directory, type pack -d autolink
7. Make sure CONFIG.SYS has a lastdrive=z statement

© 3Com Corporation