Syntax

SHow -APPN RTP [name]

No default

Description

The RTP parameter displays RTP connections. If you do not specify a name, then all RTP connections are displayed.

The following is an example of the display obtained by entering the SHow -APPN RTP command:

==================================== SHow -APPN RTP ===================================
Name	Link	Dest	COS	BTU	#SESS	ALIVE(val,t_out)
1. 3C000001	LINK001	US3COMHQ.CUBE	#INTER	1033	2	180 4
(US3COMHQ.IBM4 - GOLD - SILVER - CUBE)
2. 3C000003	LINK0001	US3COMHQ.PEBBLE	3INTER	1033	4	180 6
(US3COMHQ.IBM4 - GOLD - SILVER - CUBE - PEBBLE)

The first line of the display shows specific information for the RTP connection. The second line of the display shows the Route Selection Control Vector (RSCV) list of the RTP path. For the first entry, the RSCV list contains the network name in addition to the node name. For subsequent nodes in the path, if the node belongs in the same network as the preceding node, the network name is not displayed.

Table 28 explains the meanings of the RTPStats display.

Table 28 RTP Display Meanings

Display Heading	Meaning
Name	The RTP connection name.
Link	The first hop link name.
Dest	The destination node name.
COS	The class of service name.
BTU	The maximum BTU size.
#Sess	The number of active sessions.
ALIVE (val,t_out)	Values for the ALIVE timer. The first number, val, indicates the ALIVE timer setting (in seconds) for the RTP connection. The second number, t_out, indicates the number of timeouts, or the number of times the ALIVE timer expired, on the RTP connection.