Syntax

SETDefault -APPN ConnNetworkChar = <cn name> [EffectCap=<string>] [ConnectCost=<0-255>] [ByteCost=<0-255>] [Security=<string>] [PropDelay=<string>] [Usd1=<0-255>] [Usd2=<0-255>] [Usd3=<0-255>]

SHow -APPN ConnNetworkChar <cn_name>

No default

Description

The ConnNetworkChar parameter specifies TG characteristics for a connection network. You can specify any value you want to change; any value not specified will not be affected.

Values

<cn name>	Specifies the name assigned to the connection network.
EffectCap	Specifies the highest bit transmission rate that the TG can obtain. Specify one of the following values: MINimum, MAXimum, 2400, 4800, 9600, 19200, 56000, 64000, 2560000, T1, 4M, 10M, 16M, 25M, 100M, or 155M. The default values are those used by the connection network's TG profile. You must enter this value using one of these strings; however, these strings map to specific hex values. For information on mapping the hex values to these strings, see Table 15 earlier in this chapter.
ConnectCost	Specifies the relative cost per unit time of using a TG. Valid values are from 0-255. The default is 0.
ByteCost	Specifies the relative cost per byte for using a TG. Valid values are from 0-255. The default is 0.
Security	Specifies the level of security available on the TG. Specify one of the following strings: NONsecure, PKTswtnet, UNDgndcbl, SECurcnd, GUArdcnd, ENCryptd, guardRAD, or MAX. The default values are those used by the connection network's TG profile. You must enter this value using one of these strings; however, these strings map to specific hex values. For information on mapping the hex values to these strings, see Table 24 later in this chapter.
PropDelay	Specifies the length of time in microseconds for a signal to propagate from one end of the TG to the other. Specify one of the following strings: MINimum, LAN, TELephone, PKTswitch, SATellite, or MAXimum. The default values are those used by the connection network's TG profile.You must enter this value using one of these strings; however, these strings map to specific hex values. For information on mapping the hex values to these strings, see Table 25 later in this chapter.
Usd1	Specifies the value for user-defined parameter 1. The user-defined parameters represent TG characteristics defined by the network administrator. Valid values are from 0-255. The default is 128. These values also apply to user-defined parameters 2 and 3.
Usd2	Specifies the value for user-defined parameter 2.
Usd3	Specifies the value for user-defined parameter 3.