![[previous]](../../../graphics/l_arrow.gif){kind=icon}
![[next]](../../../graphics/r_arrow.gif){kind=icon}
Syntax
SETDefault !<path> -PAth DUplex = Full | Half | Auto
SHow [!<path> | !*] -PAth DUplex
SHowDefault [!<path> | !*] -PAth DUplex
Auto
The DUplex parameter specifies the physical characteristics of the communications method used to control the request-to-send (RTS) signal on the serial line. Selecting the full-duplex transmission mode can eliminate the turnaround time and maximize the line use. Half duplex is necessary if the attached modem or device configuration requires half-duplex operations. Depending on the interface, Auto specifies either full or half duplex:
Before changes to this parameter can take effect, -PAth CONTrol must be enabled.