SETDefault !<connectorID.channelID> -PAth LocalSubAddr = "<string>"

SHow [!<connectorID.channelID> | !<connectorID>.*] -PAth LocalSubAddr

SHowDefault [!<connectorID.channelID> | !<connectorID>.*] -PAth LocalSubAddr

No subaddress configured

Description

The LocalSubAddr parameter configures a subaddress to the phone number you specified for an ISDN path using the -PAth LocalDialNo parameter. A subaddress resembles a phone extension. When specifying a subaddress, valid characters include up to 20 ASCII characters.

You need to specify a subaddress if you have assigned the same phone number to more than one ISDN path in your point-to-point or point-to-multipoint configuration. The telecommunications carrier does not provide a subaddress; you must create your own.

Not all telecommunications carriers allow you to assign the same phone number to multiple paths. When you contact your carrier to acquire support services, verify that they support this feature. You must also specify that you will be using subaddresses.

For more information on subaddresses, see Using Enterprise OS Software.

For the configuration of this parameter to take effect, you must re-enable the channel using the -PAth CONTrol parameter. For more information, see "CONTrol" earlier in this chapter.