SHDlc Service Parameters

This chapter describes the parameters related to tunneling synchronous data link control (SDLC) or high-level data link (HDLC) control frames through Transmission Control Protocol/Internet Protocol (TCP/IP). Table 113 lists the SHDLC parameters and commands.

Table 113 SHDlc Service Parameters and Commands

Parameter	Commands
PEer	SETDefault, SHow

Syntax

SETDefault !<port> -SHDlc PEer = <peer mac address (noncanonical)> | None

SHow -SHDlc PEer

No default

Description

The PEer parameter sets the MAC address of the peer port that the -SHDlc Service is going to use. This parameter also displays the connect state of the circuit associated with the peer port.

The MAC addresses displayed using this parameter are in noncanonical format.

Values

<peer mac address>	Identifies the MAC address of the peer port the SHDlc Service is going to use. You must enter the MAC address in noncanonical format.
None	Specifies that the SHDlc Service is not going to use a peer port and clears the previously configured peer MAC address.