Syntax

FLush -SYS DpmSTATistics

SHow [!<port|slot>] -SYS DpmSTATistics [POrt | SLot] [SRc | DEst] [<protocol>]

SLot, SRc, SUmmary

Description

The DpmSTATistics parameter displays information about the forwarding behavior of the distributed protocol modules (DPMs) and gives details about how unicast and multicast network traffic was handled by the DPM. The statistics are valid only for traffic originating from an I/O module that supports DPMs. A count of the packets forwarded to the destination ports, slots, or DPE is displayed. When the parameter is used with the FLush command, all DPM statistics are zeroed out.

Values

!<port | slot>	The port or slot instance for which statistics are required. If no instance is specified, statistics are displayed for all ports or slots.
POrt | SLot	Determines if the display should be on a per-port or per-slot basis. The default is per-slot.
SRc | DEst	When the SRc value is specified, data is displayed about packets transmitted from the specified slots or ports, or ports or slots which are the source of the packets. The DEst value displays data about packets received on the specified slots or ports, or the ports or slots that are the destination of the packets.
<protocol>	The following keywords can be used for protocol: SUmmary | ALl | BRidge | IP | IPX SUmmary summarizes the data for all protocols by adding numbers for all protocols and displaying only one set of statistics. The SUmmary value is the default. ALl displays statistics about all known protocols that have a distributed protocol module. When BRidge, IP or IPX is specified, statistics are displayed only for the protocol listed.