SR Service Parameters

This chapter describes the Source Route (SR) Service parameters for operating source route bridging and end system source routing. When configuring parallel bridges, 3Com recommends that you configure both bridges in the same bridge mode, source route (SR) or source route transparent (SRT), to prevent unexpected blocking of one type of traffic.

Table 125 lists the SR Service parameters and commands.

.

Table 125 SR Service Parameters and Commands

Parameters	Commands
AllRoutes	FLush, SHow, SHowDefault
BridgeNumber	SETDefault, SHow
CONFiguration	SHow, SHowDefault
DIAGnostics	SHow
GatewayControl	SETDefault, SHow, SHowDefault
GatewayVRing	SETDefault, SHow, SHowDefault
HoldTime	SETDefault, SHow, SHowDefault
LargestFrameSize	SETDefault, SHow, SHowDefault
MaxAreRDLimit	SETDefault, SHow, SHowDefault
MaxSteRDLimit	SETDefault, SHow, SHowDefault
MinAccessPrior	SETDefault, SHow, SHowDefault
Mode	SETDefault, SHow
RingNumber	SETDefault, SHow, SHowDefault
ROUte	ADD, DELete, SHow, SHowDefault
RouteDiscovery	SETDefault, SHow, SHowDefault
SrcRouBridge	SETDefault, SHow, SHowDefault
WanRoutes	FLush, SHow